THERMOCOMP™ COMPOUNDS FOR DIELECTRIC SOLUTIONS
LNP™ THERMOCOMP compounds portfolio contains thermoplastic injection molding materials that offer low Dissipation Factor (Df) for improved signal gain and longer reading distance paired with tailor made Dielectric Constants (Dk) to fine tune or detour a signal direction supporting innovative antenna designs. Beyond that, THERMOCOMP compounds allow further antenna miniaturization and the design of phase shifters with higher productivity through combined high Dk and low Df material properties.
TYPICAL INDUSTRY REQUIREMENTS:
• Materials for individual antenna design to fine tune or detour signal direction
• Improved signal gain and longer reading distance through less signal attenuation
• Miniaturized antenna solutions with sufficient signal strength for 5G technology
• Improved mechanical performance versus Epoxy or Ceramics in more complex designs for less maintenance through longer lifetime
TYPICAL MATERIAL CHARACTERISTICS:
•Tailored Dielectric Constant Dk by customized compound formulations
• Very low Dissipation Factor Df for lower
signal absorption, less signal scattering
• Combined high Dk and low Df with very high signal transmission density
• Sufficient flowability for thin wall design, improved ductility, dimensional and dielectric stability versus current solution
LNP™ COMPOUNDS &
LEXAN™ COPOLYMER RESINS
Over 50 years of innovation in thermoplastic compounding enables SABIC’s specialty compounds to offer extensive materials with a broad portfolio.
PRODUCTS AND GRADES
CONTACT US
Reach out to us for one-on-one support to ensure you have all the information and insights you need to choose the best-fit material for your application.
DISCLAIMER: THE MATERIALS, PRODUCTS AND SERVICES OF SAUDI BASIC INDUSTRIES CORPORATION (SABIC) OR ITS SUBSIDIARIES OR AFFILIATES (“SELLER”) ARE SOLD SUBJECT TO SELLER’S STANDARD CONDITIONS OF SALE, WHICH ARE AVAILABLE UPON REQUEST. INFORMATION AND RECOMMENDATIONS CONTAINED IN THIS DOCUMENT ARE GIVEN IN GOOD FAITH. HOWEVER, SELLER MAKES NO EXPRESS OR IMPLIED REPRESENTATION, WARRANTY OR GUARANTEE (i) THAT ANY RESULTS DESCRIBED IN THIS DOCUMENT WILL BE OBTAINED UNDER END-USE CONDITIONS, OR (ii) AS TO THE EFFECTIVENESS OR SAFETY OF ANY DESIGN OR APPLICATION INCORPORATING SELLER’S MATERIALS, PRODUCTS, SERVICES OR RECOMMENDATIONS. UNLESS OTHERWISE PROVIDED IN SELLER’S STANDARD CONDITIONS OF SALE, SELLER SHALL NOT BE RESPONSIBLE FOR ANY LOSS RESULTING FROM ANY USE OF ITS MATERIALS, PRODUCTS, SERVICES OR RECOMMENDATIONS DESCRIBED IN THIS DOCUMENT. Each user is responsible for making its own determination as to the suitability of Seller’s materials, products, services or recommendations for the user’s particular use through appropriate end-use and other testing and analysis. Nothing in any document or oral statement shall be deemed to alter or waive any provision of Seller’s Standard Conditions of Sale or this Disclaimer, unless it is specifically agreed to in a writing signed by Seller. Statements by Seller concerning a possible use of any material, product, service or design do not, are not intended to, and should not be construed to grant any license under any patent or other intellectual property right of Seller or as a recommendation for the use of any material, product, service or design in a manner that infringes any patent or other intellectual property right. SABIC and brands marked with ™ are trademarks of SABIC or its subsidiaries or affiliates, unless otherwise noted.
© 2023 Saudi Basic Industries Corporation (SABIC). All Rights Reserved.
Any brands, products or services of other companies referenced in this document are the trademarks, service marks and/or trade names of their respective holders.
Your PDF is downloading. Please wait.
Register for High value Multi-Point Data
- Access validated product data to streamline material selection
- Get inspired by innovative application ideas
- Register for high value multi-point data and a personalized experience
